US Robotics USR4204 Guide de l'utilisateur télécharger pdf (Page 43)

USR4204 User Guide

Page 43 of 69

Config Security Menu (Main Menu



At the top of the Configure Security Menu is the menu name. A list of valid commands, text,

and status follows. Invalid commands are ignored.

Use a Select command (see below) to set up the Administrator and up to 15 User accounts.

'0' Select Admin

Navigate to the Administrator Menu with this command. It is the only command available on

this menu if security is off. Use this command to setup the Administrator account and turn

on security.

Batch Mode Command: None

'1'–'9' and 'A'–'F' Select User

Navigate to the corresponding User Menu with this command. The current User status

(ON/OFF) is shown in parentheses next to the User name. Use this command to setup a

User account.

NOTE: To disabled a user or re-enable a locked-out user, select the user then

Toggle the User Enable status to 'ON'.

Batch Mode Command: None

'-' Return to Configure Parameters Menu

Navigate back to the Configure Parameters Menu with this command.

Configure Security Menu (current enabled state in parentheses below)

CMD CMD

'0' Select "Admin Username " Admin '8' Select " " (OFF)

'1' Select " " (OFF) '9' Select " " (OFF)

'2' Select " " (OFF) 'A' Select " " (OFF)

'3' Select " " (OFF) 'B' Select " " (OFF)

'4' Select " " (OFF) 'C' Select " " (OFF)

'5' Select " " (OFF) 'D' Select " " (OFF)

'6' Select " " (OFF) 'E' Select " " (OFF)

'7' Select " " (OFF) 'F' Select "User 15 " (ON )

'-' Return to Config Parameters Menu '&' Remove ALL Accounts

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 68 69

Pas de commentaire

US Robotics USR4204 Guide de l'utilisateur Page 43