US Robotics USR4204 Guide de l'utilisateur télécharger pdf (Page 40)

USR4204 User Guide

Page 40 of 69

If S/W flow control is desired, it must be enabled on both the USR4204 and

the modem attached to the USR4204 terminal port

Batch Mode Command: FF=

Valid values: 1=on, 0=off

'P' Toggle Xon/Xoff Pass Thru

Xon/Xoff flow control characters are allowed to pass through the terminal port and all serial

ports with this command.

Default: Off

Batch Mode Command: FP=

Valid values: 1=on, 0=off

'E' Toggle Command Echo

The terminal port can echo back to the terminal all valid commands and text it received.

Disable or re-enable echoing with this command.

Default: On

Batch Mode Command: FE=

Valid values: 1=on, 0=off

'A' Toggle Auto CR

The terminal port can accept single digit commands without an explicit carriage return

(0Dh). Disable or re-enable Auto CR with this command.

Default: On

Batch Mode Command: FA=

Valid values: 1=on, 0=off

'D' Toggle DCD Override

The terminal port can monitor the incoming DCD (or DTR) signal. When DCD is not

overridden, a rising edge will cause the terminal port to send the main menu or the login

prompt. A falling edge will close any open serial port, and logout the session if security is

enabled. Enable or disable DCD override with this command.

Default: Off

Batch Mode Command: FD=

Valid values: 1=on, 0=off

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 68 69

Pas de commentaire

US Robotics USR4204 Guide de l'utilisateur Page 40