US Robotics USR4204 Guide de l'utilisateur télécharger pdf (Page 31)

USR4204 User Guide

Page 31 of 69

To update the RMS value, refresh the Main Menu by hitting the spacebar, Enter key, or

using the Refresh Menu (default '–') command.

Batch Mode Command: None

'5'- '6' Disable Power Port

These commands each control a USR4204 power port. When a disable command is entered,

power from the mains power input is disconnected (regardless of the previous state) from

outputs 1 or 2 after entering a ‘Y’ at the “Are you sure?” prompt. The current power port

state (ON or OFF) and RMS load current are then shown in parentheses next to the port

name.

To update the RMS value, refresh the Main Menu by hitting the spacebar, Enter key, or

using the Refresh Menu (default '–') command.

Batch Mode Command: None

'M'- 'N' Reboot Power Port

These commands each control a USR4204 power port. When a reboot command is entered,

power from the mains power input is disconnected (regardless of the previous state) from

output 1 or 2 for approximately 10 seconds after entering a ‘Y’ at the “Are you sure?”

prompt, then reconnected. The current power port state (ON or OFF) and RMS load current

are shown in parentheses next to the port name.

No commands are accepted during the reboot time. To update the RMS value after reboot is

complete, refresh the Main Menu by hitting the spacebar, Enter key, or using the Refresh

Menu (default '–') command.

Batch Mode Command: None

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 68 69

Pas de commentaire

US Robotics USR4204 Guide de l'utilisateur Page 31