US Robotics COURIER Manuel d'utilisateur télécharger pdf (Page 52)

100

101

U.S. Robotics I-modem Command Reference

Working with Memory • Page 4-18

Note DIP switch settings override AT commands at power-on. Make sure DIP

Switch 1 is ON, or the &F0 template will be loaded!

Default Settings

If DIP switch 1 is OFF at power-on, the &F0 settings are loaded instead.

By default, the Þrst time the I-modem is turned on, it loads the settings stored in NVRAM,

which are the same as the settings in the &F1 template.

Until you save any changes to NVRAM, the defaults stored there are the same as the per-

manent R

OM factory settings stored in &F1.

To view the &F1 settings, enter ATI5.

Saving Templates in NVRAM

You can save any of the three templates, or save modiÞed versions of them, in NVRAM

for use as power-on defaults.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 307 308

Commentaires sur ces manuels

Pas de commentaire

US Robotics COURIER Manuel d'utilisateur Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau US Robotics COURIER