US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manuel d'utilisateur télécharger pdf (Page 20)

56K Softmodem

Command Reference

- 14

L<value>—Speaker Volume

Use this command to set the monitor speaker volume setting when the speaker is

on. Result codes:

OK if <value> = 0—3.

ERROR if <value> does not equal 0—3.

Table 3-9: L<value> Commands

M<value>—Speaker Control

Use this command to turn the monitor speaker on or off. Result codes:

OK if <value> = 0—3.

ERROR if <value> does not equal 0—3.

Table 3-10: M<value> Commands

N<value>—Modulation Handshake

Use this command to set the modem protocol for handling handshake negotiation

at connection time if the communication speed of the remote modem is different

from the speed of the local modem.

Result codes:

OK if <value> = 0—1.

ERROR if <value> does not equal 0—1.

Command Function

L0 Low volume.

L1 Low volume.

L2 Medium volume (default).

L3 High volume.

Command Function

M0 Speaker is off.

M1 Speaker is on until the modem detects the carrier signal (default).

M2 Speaker is always on when the modem is off-hook.

M3 Speaker is on until the carrier is detected, except when dialing.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 107 108

Pas de commentaire

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manuel d'utilisateur Page 20