US Robotics USR803510 Guide de l'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 158
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Revision: 1.00 Copyright 2015 U.S. Robotics Corporation 17 | P a g e
4. Slide the card into slot, using the side channels or grooves on the device to guide the card into
place. Make sure the screw holes line up.
5. Push gently until the card is flush with the housing.
6. Secure the card with the screws.
The following table lists the expansion cards available from Option and the slot.
Expansion Card
Slot
Wi-Fi Card (CG2101)
Back
Low Cost Serial Card (CG1101) included in the base unit
Front
Industrial Serial Card (CG1102)
Front
Basic Ethernet Switch (CG1104)
Front
PoE Ethernet Switch (CG1103)
Front
Developers Card (CG1105)
Front
Removing Expansion Cards
1. Remove the Torx screws that fasten the card to the base unit.
2. Plug a connector into the mating connector on the expansion card. If the card has multiple
connectors, choose a connector near the right edge.
3. Remove the expansion card by pulling the plug or cable that is inserted into an expansion card
connector.
Note: The expansion card faceplate will deform if the card is pulled at the edge.
Do not attempt to remove the expansion card by pulling its edge!
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 157 158

Commentaires sur ces manuels

Pas de commentaire