US Robotics USR5462 Guide de l'utilisateur télécharger pdf (Page 11)

Installing the 802.11g 54Mbps Router

1. Launch a Web browser. In the location or address line of your Web

browser, type

http://192.168.2.1 to access the Web User Interface.

After the connection is established, you will see the Web User Interface.

The default password is admin. Click Login.

When you access the Web User Interface, click the Setup Wizard.

Note: If you are prompted to connect to the Internet, you may need to select

Try Again or Connect, depending on your Internet browser.

2. Select your Time Zone and then click Next.

3. Choose your Broadband Type. (Enter the appropriate information for

the type of Internet connection you chose.) When you are finished, click

Next. Refer to “Broadband Type” on page 12 for more information.

4. If required, enter the IP address Info for the 802.11g 54Mbps Router and

then click Finish.

After finishing the Setup Wizard, if it does not report "Connected," perform

the steps of the Setup Wizard again.

If Web User Interface still did not report “Connected,” or if at anytime you

want to validate your Internet settings, click Advanced Setup and select

Status.

To make a wireless connection:

Make sure each wireless adapter that will be connected to the network is

set to Infrastructure mode. If you purchased the USR5470 Wireless Starter

Kit, refer to the Navigating the Wireless Configuration Utility section of the

802.11g 54Mbps USB Adapter User Guide on the Installation CD-ROM to

determine how to change this setting and for instructions on collecting

your configuration information. If you are connecting a different wireless

adapter, refer to that wireless adapter’s documentation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 77 78

Pas de commentaire

US Robotics USR5462 Guide de l'utilisateur Page 11