US Robotics USR8700 Guide de l'utilisateur Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 156
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
Serial ATA 4-Drive NAS
User Guide
Getting Started - 14
2. Near the front of the tray is a spacer containing four screws. Squeeze the tabs toward each other to
remove the spacer from the tray.
3. With the flat edge of the spacer up and the screws facing a flat surface (such as a table or desk top),
flex the sides of the spacer apart from each other to release the screws.
4. Make sure that the hard disk is a SATA disk. It should have a SATA connector similar to the following:
5. Slide the new hard disk into the tray (connector end down and toward the back of the tray), and fasten
the screws on the sides of the tray:
6. Slide the hard disk and tray back into the storage system until it snaps into place.
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 155 156

Commentaires sur ces manuels

Pas de commentaire