US Robotics USR2410 Manuel d'utilisateur télécharger pdf (Page 47)

Table 6-2: Machine Cloning Commands

Machine Cloning Commands

dd if=/dev/hda of=/dev/hdb

where dev/hda is the hard drive containing the complete system.

dev/hdb is the destination hard drive

Once a host machine was configured with two hard drives, one to be read from and one to be

written to, the copy took about 20 minutes. Once the cloned hard drive was installed back into the

other machine, there were a few steps required to configure it. The following list summarizes the

final steps needed to configure the newly cloned machine:

1. The /etc/conf.d/hostname, /etc/csh.env, /etc/env.d/01hostname, /etc/profile.env files were

updated to specify the new hostname.

2. The configuration file for the Click Modular Router was changed to specify the IP address of

the new machine.

After these files were updated, a reboot was all that was needed to have the machine configured

with all the software requirements of a mesh router.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 106 107

Pas de commentaire

US Robotics USR2410 Manuel d'utilisateur Page 47