US Robotics USR5453 Guide d'installation télécharger pdf (Page 13)

My wireless device cannot find the wireless network.

Possible Solution 1:

Ensure that the access point is broadcasting its SSID:

1. Open the Web User Interface of the access point.

2. From the Advanced menu, select Security.

3. Verify that Broadcast SSID is set to Allow.

4. Click Update to save any change.

Possible Solution 2:

Reboot the access point by disconnecting and then reconnecting its power adapter.

My wireless device cannot connect to the wireless network.

Possible Solution 1:

Ensure that the wireless device is set to Infrastructure mode and has the following settings in

common with the access point:

• SSID, also called Network Name.

• Kind of security (for example, WPA/WPA2)

• Security key value

If you change the settings on the access point, remember to change the settings on your wire-

less devices also.

Possible Solution 2:

I am experiencing poor wireless link quality.

Possible Solution 1:

Reposition the access point or the wireless device so that environmental factors, such as lead-

based paint or concrete walls, do not interfere with your wireless signal.

Possible Solution 2:

Create a wireless connection on a different channel so that electronic devices, such as 2.4 GHz

phones, do not interfere with your wireless signal. For more information about changing chan-

nels, see “Channel Management” in the

Administrator Guide

I need to configure the access point with an operating system other

than Windows.

Possible Solution:

You must configure the access point through its Web User Interface as follows:

1. Find the access point’s IP address:

■

Using the configuration program for the networking device, such as a router,

to which the access point is connected, view the device’s client list.

■

Find the LAN MAC address of the access point in the client list.

■

Note the IP address that corresponds to the LAN MAC address of the access

point.

2. Launch a Web browser, type the IP address of the access point in the browser’s nav-

igation bar, and press Enter.

3. You can now log in and perform access point configuration as described in “Step 3:

Configure Basic Settings.”

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

US Robotics USR5453 Guide d'installation Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau US Robotics USR5453